Steps
STEP 1
Measure out where the middle is on the tile on both the horizontal and vertical using the tape measure and a pencil. Tape down letters with the tracing paper onto the tiles. Trace on top of the letters with a pencil and peel off the paper.
Tools
Tape Measure, Pencil
Materials
Tracing Paper, Slate Coasters
![Peeling off tracing paper](https://2e1293630802db8d0d56-50fcdb1c10e3e49a3d1b0541a2f13b69.ssl.cf1.rackcdn.com/projects/steps/a24990194d514f4bb3a4859dc2fe5d43.png)
STEP 2
Insert the ball engraving burr into the 18V ONE + precision craft rotary tool. Set speed to low for control, then carefully engrave all of the letters into the tiles.
Tools
Ball Engraving Burr, Rotary Tool
Materials
Slate Coasters
![Engraving tile](https://2e1293630802db8d0d56-50fcdb1c10e3e49a3d1b0541a2f13b69.ssl.cf1.rackcdn.com/projects/steps/fb994592038440509fbf3f5466a741dc.png)
STEP 3
Use the power cutter to cut a piece of twine. Stack the tiles, then cross the twine under them, using the 18V ONE + glue gun to secure to the bottom. Flip them over, then tie a bow at the top and add a dot of glue to secure.
Tools
Power Cutter, Glue Gun
Materials
Slate Coasters, Twine
![Cutting twine](https://2e1293630802db8d0d56-50fcdb1c10e3e49a3d1b0541a2f13b69.ssl.cf1.rackcdn.com/projects/steps/083218676ab84e83ba6aad630b57ade6.png)