Steps
STEP 1
On one end of the 1"x 3" board measure 2-1/2" and mark to cut. Then draw crossing line to find center.
STEP 2
At intersection of lines, drill a 1-7/8" hole with Hole Saw.
Tools
Drill
STEP 3
Cut piece of wood at 2-1/2" mark. Repeat steps 1 & 2 to make three tube holder pieces.
Tools
Miter Saw
STEP 4
Measure 8-1/2" and mark on 1"x 3" board, cut to length.
Tools
Miter Saw
STEP 5
Cut 1"x 6" board to 9-1/2" long. Sanding pieces prior to building can make the process easier before final assembly. Refer to last page for sanding information.
Tools
Miter Saw
STEP 6
Align base piece to bottom edge of back board and center. This will give you a 1/2" space on both sides. Attach with glue and pin nails from the back.
Tools
Pin Nailer
STEP 7
Follow diagram for mounting location of tube holders. Attach with glue and pin nail from the back.
Tools
Pin Nailer
STEP 9
Finish to your desire.
